archive
archive valves
archive
archive valves
12J8 tube: datasheets and technical data
Explore available pinout, electrical data and related types for the 12J8 vacuum tube.
The 12J8 combines two diodes and a tetrode in a miniature nine-pin Noval bulb. Tung-Sol’s provisional June 1, 1957 sheet and RCA’s April 1959 sheet describe it for car radios powered directly by a nominal 12 V battery; RCA assigns the tetrode an audio-driver role. Low-voltage supply defines this application: the documented audio operating point uses only 12.6 V on both anode and screen grid. The description “power tetrode” therefore does not imply output comparable to a conventional high-voltage audio output valve.
The heater draws approximately 325 mA at 12.6 V. Tung-Sol allows AC or DC and explains that it accommodates automotive battery variations over 10–15.9 V. RCA also specifies this absolute range, but the two copies consulted recommend respectively 12–14 V and 11–14 V for longer life; this difference between versions is retained rather than merged. The bottom-view 9GC pinout assigns control grid to 1, tetrode cathode to 2, screen to 3, heater to 4 and 5, tetrode anode to 6. Both diodes share cathode 7, with separate anodes on 9 for the first and 8 for the second. Any mounting position is permitted.
RCA’s typical audio point, with heater, anode and screen at 12.6 V and specified grid voltage 0 V, uses a 2.2 MΩ grid resistor bypassed by 1 µF. Quiescent currents are anode 12 mA and screen 1.5 mA; transconductance is 5.5 mA/V and anode resistance approximately 6 kΩ. With a 2.7 kΩ load and 1.6 V RMS grid signal, specified maximum-signal output is 20 mW at 5% total harmonic distortion. Tung-Sol gives the same principal values. These are conditions for a particular driver stage, illustrating its operating scale, not a performance promise for every circuit.
Without an external shield, tetrode capacitances are grid–anode 0.7 pF, input 10.5 pF and output 4.4 pF; coupling between tetrode grid and the two diode anodes is limited respectively to 0.04 and 0.015 pF. Design-Center limits are tetrode anode and screen 30 V, peak heater–cathode 30 V either polarity, control-grid circuit resistance maximum 10 MΩ. Each diode permits maximum average current 5 mA. Care with the designation avoids confusion: the Soviet 12Ж8 found in other documentation is a metal-cased octal RF pentode; its data do not describe this Noval double-diode tetrode.
Tube images
Pinout and connections
Base: Noval (B9A)
Electrical data
Heater
- Heater voltage Vh
- 12.6 V
- Heater current Ih
- 0.325 A
Datasheet PDF
EL84 ECC83 12AX7 EL34 6L6GC 300B KT88 GZ34
How to use the Valve Archive
EnryLab Valve Archive allows you to search for PDF datasheets and technical documentation by entering the exact code of a vacuum tube. Enter codes such as EL84, ECC83, 12AX7, 6L6GC, or 300B to view variants, manufacturers, and documents available in the technical archive. The search uses exact matches, thus avoiding partial or irrelevant results and making it easier to find the correct datasheet.
Datasheet PDF and frequent searches
The most searched acronyms have dedicated and indexable pages, with clean URLs and linked documentation. You can start with frequent searches to quickly consult the most used valves in the audio, radio, and technical restoration fields.