archive

archive valves

EF89 tube: datasheets and technical data

Explore available pinout, electrical data and related types for the EF89 vacuum tube.

5 PDF datasheets available

The EF89 is a variable-transconductance pentode for radio-frequency or intermediate-frequency amplification. Philips and Mazda-Belvu explicitly describe it for these stages; Brimar notes its suitability for FM receivers. Its control characteristic allows gain to be reduced by making the control grid more negative as the signal grows. This distinguishes the EF89 from a sharp-cutoff pentode used where gain should remain substantially fixed. The preserved sheets include a Philips document dated 1955 and later documentation: the sheet date establishes that the type was documented then, not by itself the year production began.

The tube has a 6.3 V, 0.2 A heater suitable for AC or DC supply; Philips sheets specify parallel heater operation. The base is noval. Mazda-Belvu shows separate connections for the internal shield, control grid, cathode, plate and other grids: wiring and shielding matter in RF and IF stages. The stated capacitances are 5.5 pF at the input, 5.1 pF at the output and a maximum of 0.002 pF between control grid and plate under the datasheets' measurement conditions. This very low last value limits unwanted coupling from output to input.

A typical Philips point with 250 V on the plate, 100 V on the screen grid and −2 V on the control grid gives 9 mA of plate current, 3 mA of screen current and 3.6 mA/V of transconductance. In application conditions with a 250 V supply, a 51 kΩ screen resistor and a 160 Ω cathode resistor, transconductance is about 3.5 mA/V near −1.95 V on the grid, but falls to about 0.24 mA/V when the control voltage reaches −20 V. This comparison illustrates gain control without assigning the same current to both points. Design limits specify a maximum of 300 V in operation for plate and screen, 2.25 W plate dissipation, 0.45 W screen dissipation and 16.5 mA cathode current. The sheets also warn that grid current may occur at some bias points: the notes must be read and the appropriate bias circuit chosen.

Tube images

Pinout and connections

Pinout diagram

Base: Noval (B9A) (9 pin)

PinFunction
1s
2g1
3k
4h
5h
6s
7a
8g2
9g3

Electrical data

Heater

Heater voltage Vh
6.3 V
Heater current Ih
0.2 A

Datasheet PDF

EL84 ECC83 12AX7 EL34 6L6GC 300B KT88 GZ34

74,001 Valvole ricercabili sul sito
18,704 Datasheet PDF disponibili

How to use the Valve Archive

EnryLab Valve Archive allows you to search for PDF datasheets and technical documentation by entering the exact code of a vacuum tube. Enter codes such as EL84, ECC83, 12AX7, 6L6GC, or 300B to view variants, manufacturers, and documents available in the technical archive. The search uses exact matches, thus avoiding partial or irrelevant results and making it easier to find the correct datasheet.

Datasheet PDF and frequent searches

The most searched acronyms have dedicated and indexable pages, with clean URLs and linked documentation. You can start with frequent searches to quickly consult the most used valves in the audio, radio, and technical restoration fields.